The floppy diskette may not be formatted. The block size will depend on the type of hard disk drive. Make sure this field is set to Enabled. Front Audio The front audio connector J1 allows you to connect to the line-out and mic-in jacks that are at the front panel of your system. Make sure they do not conflict with the settings of the IDE hard drives.

Uploader: Kazrazilkree
Date Added: 3 July 2014
File Size: 12.54 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 48540
Price: Free* [*Free Regsitration Required]

DFI 848P-AL Manuals

Danger of explosion if battery incorrectly replaced. Your system supports five modes, 0 default to 4, which primarily differ in timing. If you want to use the default voltage, leave this field in its default setting. The Control Panel dialog box will appear. Shielded interface cables must be used in order to comply with the emission limits. Push and release again in less than 4 sec to restore. The floppy diskette may not be formatted.

Sign up to get insider deals first, exclusive promotions and more delivered to your inbox each week. Make sure your software is configured for the right type of printer attached.


User`s manual | DFI 848P-AL Motherboard

The sequence of the pin functions on some IrDA cable may be reversed from the pin function defined on the system board. Verify that the device is plugged into the correct serial port on the rear of the computer.

The multilingual manual is included in the system board package. When the system enters the HDD Power Down mode according to the power saving time selected, the hard disk drive will be powered down while all other devices remain active. This publication is provided for informational purposes only.

Volume Control This panel provides digital volume control for all 6 channels.

Gold mark Pin 1 4. Now power-on the system. Keyboard error or no keyboard present Cannot initialize the keyboard. Lever 20 Hardware Installation 2 3.

You must have two floppy drives to use this function. This can indicate that CMOS has become corrupt. Unlock the socket by pushing the lever sideways, away from the socket, then lifting it up 84p-al a 90o angle.

DFI P-AL Motherboard |

Make audlo pin 1 of the cable connector is aligned with pin 1 of J1. Refer to chapter 4 for instructions on using the DMI utility. Format the diskette and try again.


These apply to a standard specification and will depend on the type and speed of your device. Your system configuration amount of memory, add-in cards, peripherals, etc.

Make sure the socket is lifted to at least this angle otherwise the CPU will not fit in properly. This is to ensure an accurate diagnosis of the problem in case a problem has multiple causes. The processor shown under Computer should resemble the one shown below.

It allows you to configure 2-channel, 4-channel and 6channel audio modes as well as configure the audio effects.

DPMS Initializes display power management signaling.

Seat the module vertically into the socket. TigerDirect Business is not responsible for typographical or photographic errors.

Award is a registered trademark of Award Software, Inc.