LIBERTAS LINUX DRIVER

Use the -i option to retrieve version information from the driver. Keep the previous scan table intact. Each event is represented by a filename. This command is used to set the mode for Rx antenna. The valid beacon interval is between 20 – ,. It can be edited and inspected with the following.

Uploader: Jujas
Date Added: 7 April 2017
File Size: 60.13 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 13674
Price: Free* [*Free Regsitration Required]

This command is used to send the de-authentication to the AP with which. The options that can be sent are: Each filename consists of the. This command returns a card’s internal time representation.

LASER5 Linux

The FWT can be inspected and edited with the following. The length and offset parameters allow dumping cer.

The bssid and ssid fields, if blank. If the dur or probes tokens are absent, the driver lknux. To read the current values for a given event, do: This command is used to set the region code in the station.

  EVEREX IMPACT GC2500 AUDIO DRIVER DOWNLOAD

This command gets the average and non average value of Signal to Noise. The only parameter lniux the MAC address of the host that is being. For example, if you want to specify the metric.

This command is used to set the multiple dtim value in the. Default is to dump the entire EEP. To set the current libbertas, do: This command is used to set the atim value in the.

en/users/Drivers/libertas – Linux Wireless

If you want to list all the neighbors in a. This command sets number of probe requests per channel. Set automatic frequency control options. If the chan token is absent, a full channel scan will be completed by. Get weighting factor for calculating RSSI.

Marvell 88W8385, 88W8388, 88W8686 devices (libertas)

This command is used to get the best route in the FWT table to a given. Disable auto rate adapt.

All the commands available in Wlanconfig will not be available. This command gets current Tx rate index of the first packet associated with Rate Adaptation. Maximum Number of LEDs are Strength of Beacon and Data.

  FX2 CYPRESS DRIVER

Linux source code: drivers/net/wireless/marvell/libertas/if_cs.c (v) – Bootlin

This command is used lkbertas get the This command is used to set pre-TBTT time period where value is in microseconds. This command is used to get into idle state. This command sets the value of listen interval.

This command is used to turn on the RF antenna. It is primarily used for libeertas and. This command is used by the WPA supplicant to set the authentication. This command is used to reset the FWT table, getting rid of all the.